If you catch it early, you may be able to thaw it yourself. This guide covers the signs to watch for during a Lower Mainland cold snap, what to do next, and when you need a plumber.
How to Tell If You Have a Frozen Pipe
The sign most people notice first is a tap that slows to a trickle or stops when it is turned on. A frozen pipe is the most likely cause when no water comes out of a tap, especially one that serves an outside hose bib or a cold part of the house such as a crawl space or garage.
A few more signs to watch for:
- Frost on an exposed pipe, under a sink, or along an outside wall.
- A slight musty smell near a pipe. It can mean a small crack has already opened and moisture is collecting.
- A bang or clunk when you turn on a tap, caused by water pressure building against the ice.
If you notice any of these, act on it. A frozen pipe that is left alone is a burst pipe waiting to happen.
Find the Frozen Section Before You Do Anything Else
Before you reach for the hair dryer, work out which part of the pipe is frozen. Start by checking every tap in the house. If only one or two are affected, the freeze is probably in one short section of pipe. If every tap is dry, the ice is likely closer to the main water line where it enters the house.
Check these places first:
Outside walls. The most common place for a pipe to freeze in a Surrey home is in or near an exterior wall, where there is less insulation and cold air can be drawn in around the framing.
Unheated spaces. Crawl spaces, garages, and cabinets along outside walls are the usual trouble spots, especially in older homes where the plumbing was never insulated.
Exposed pipe. Look for frost or condensation on the outside of the pipe. That is a good sign of where the ice is.
If you cannot find the frozen section, book a plumbing inspection rather than guessing.
What to Do Right Away
Step 1: Turn off the water main
Find the main shut-off valve and close it first. This matters because if the pipe has already cracked, the water behind the ice is under pressure, and that pressure is released the moment the ice starts to melt. Shutting off the water puts you in control of the situation instead of reacting to it.
If you do not know where your shut-off is, it is usually near the water meter, in the crawl space, or in the utility room.
Step 2: Open the affected tap
Turn on the tap served by the frozen pipe and leave it open. This relieves pressure and gives the water somewhere to go as the ice melts.
Step 3: Warm up the area
For a frozen section in an unheated space, set a space heater on low with the door closed. Warming the room is often enough to thaw the pipe without touching it.
If the freeze is under a sink, open the cabinet doors so the warm air in the room can reach the pipe.
How to Thaw a Frozen Pipe Safely
Once the area is warming up, you can apply gentle heat to the pipe itself. Always start at the open tap and work back toward the frozen section. That way the meltwater can run out instead of building up behind the ice.
Hair dryer. The safest and easiest tool. Keep it moving back and forth along the pipe instead of holding it in one spot. You are warming the pipe, not blasting the ice out of it.
Electric heating pad. Wrap it around the pipe and let it work slowly. Good for pipes in awkward spots.
Warm towels. Soak towels in hot water, wrap them around the pipe, and swap them every few minutes to keep the heat up.
What not to use:
- An open flame. A propane torch or any other flame has no place near a pipe or the materials around it. Heating one section too fast can crack the pipe and start a fire.
- Boiling water poured straight onto the pipe. A sudden temperature change stresses metal and plastic alike.
- A heat gun on plastic pipe. The heat is too concentrated and can melt or warp the line.
- Any heat on a section that has already split or is leaking. Shut the water off and call a plumber instead.
Signs the Pipe Has Already Burst
As the pipe thaws, watch for these signs that the damage is already done:
- Water dripping or spraying from a joint or from the pipe itself.
- A bulge or any change in the pipe’s normal shape.
- Wet or discoloured drywall around the pipe.
If you see any of these, close the tap, keep the main valve shut, and call a plumber. Thawing further on your own will make the leak worse.
When to Call a Plumber Instead of DIY
Some frozen pipes are bigger than a hair dryer can handle. Call a plumber if:
- The frozen section is inside a wall, ceiling, or floor that would have to be opened to reach it.
- You have been thawing the pipe for 30 to 45 minutes with no change.
- You see any sign of a crack or leak as the ice melts.
- The main line coming into the house is frozen.
- You are not comfortable working on the plumbing yourself.
Blue Sea Plumbing handles frozen and burst pipe emergencies in Surrey, White Rock, Ladner, North Vancouver, Maple Ridge, and Pitt Meadows. If the freeze is more than you want to take on, contact us online or give us a call.
How to Prevent Frozen Pipes Before the Next Cold Snap
Preventing a frozen pipe costs far less than repairing a burst one. A few simple jobs before winter will protect your pipes and keep you from needing an emergency repair.
- Insulate exposed pipes in crawl spaces, garages, and along outside walls. Foam pipe insulation is cheap and takes about an hour to fit.
- Seal gaps and cracks where pipes pass through outside walls.
- Disconnect garden hoses, then shut off and drain outdoor taps before the first freeze.
- Let a cold tap drip during a cold snap. Moving water takes longer to freeze than standing water.
- Know where your main shut-off valve is before you need it.
- Keep the heat on when you are away. If you leave for a few days in winter, do not set the thermostat below 13 degrees Celsius.
- Leave cabinet doors open on outside walls so room air can reach the pipes.
FAQ
How long does it take to thaw a frozen pipe?
An easy-to-reach pipe with a light freeze usually thaws in 20 to 30 minutes with a hair dryer. A harder freeze, or a pipe in an enclosed space, can take a few hours. A space heater takes longer than direct heat because it has to warm the air first.
Will a frozen pipe always burst?
Not always, but it can. Water expands as it turns to ice, and that expansion puts pressure on the pipe until it splits.
Can I run water if my pipes are frozen?
Open the affected tap a little, but do not run full pressure. If the main supply is frozen or cracked, forcing water through can make things much worse.
What pipes are most likely to freeze in a Surrey home?
The usual trouble spots are:
- Pipes in outside walls
- Unheated crawl spaces and garages
- Outdoor hose bibs and the pipes that feed them
- Pipes near the foundation, where cold air collects
Do I need a plumber if the frozen pipe did not burst?
It is worth having one take a look. A plumber can check for hairline cracks and hidden leaks that only show up later.
Ready for help? If you have a frozen or burst pipe anywhere in Surrey or the Lower Mainland, call Blue Sea Plumbing at 604-720-2862 or fill in our contact form and we will get someone out to you.



